TECHNICQLL SANITARY SILICONE WHITE 70ML S-089

Name: TECHNICQLL SANITARY SILICONE WHITE 70ML S-089
Brand: TECHNICQLL
SKU: S-089
Price: 17 PLN
Availability: InStock

zł17.00

Tax included

High-quality, one-component polysiloxane-based sanitary silicone with acetate curing system. It creates a permanently elastic joint resistant to mold, fungi and weather conditions.

Available in 24 hours

See on Allegro

Recommended for smaller renovation works
Resistant to mold and mildew
Adheres well to smooth materials
Creates a smooth and glossy grout
Flexible, does not crumble or crack

Materials: glass, metals, wood, plaster, brick, plastics, ceramic, stone, gypsum board, polystyrene foam

Examples of application:

finishing work on shower cabins bathtubs, washbasins
sealing kitchen countertops
embedding sinks
filling joints

Color: white
Consistency: tixotropic paste
Density: 0,97-0,99 g/cm3
Dry to the touch:25 min. (at 23°C and 50% humidity)
Full curing time: 2mm/24h (at 23°C and 50% humidity)
Temperature resistance: -40°C - 120°C

Working conditions: pflares perform at ambient and substrate temperatures from 5°C to 30°C.

Surface preparation: the surfaces to be glued should be clean, degreased and dry.

Application
Grouting/sealing:

Apply masking tape on both sides of the adhesive surface to ensure even
edges.
Apply a small amount of silicone and smooth with a spatula soaked in water with a little
amount of soap.
Remove the masking tapes after about 10 minutes.

Mounting/joining:

Apply silicone in spots ( at intervals of 2-3 cm) on one of the surfaces to be joined surfaces.
Tighten the joined parts.
- Moisture in the air is needed to cure the silicone, so do not
therefore do not press too tightlyso as to leave space
w for air flow between the silicone.
Leave for 24 hours for the joint to gain full strength.

Tips:

Ensure adequate ventilation during bonding operations.
When gluing objects to vertical surfaces, prepare supports of sufficient length in advance to immobilize the object for the time the silicone dries (24 hours).
Recommended joint sizes [mm] (width x depth): 4-8 x 6; 10-12 x 8; 14-16 x 10; 18-20 x 12; 22-24 x 14. Minimum joint width is 4mm, and maximum is 25mm.
Do not use for joints with Teflon, PP, PE.
Neoprene and bitumen may cause staining.
Do not use for PVC, concrete, marble, acrylic, corrosion-sensitive metals: lead, zinc, copper, iron, and for sealing aquariums and bonding mirrors.
Avoid contact with secondary seals in insulating glass units, as well as with laminated glass (especially applies to edge contact).
Fresh dirt can be removed with soapy water or extraction gasoline, while after curing with a knife or spatula.
At temperatures above 120oC, silicone becomes discolored.
Do not wet the substrate or silicone layer with water.